Quicken Connect install

Alan Howlett (ahowlett@eos.hitc.com)
Wed, 29 Mar 95 12:13 PST

I purchased Quicken for Windows after trying Quicken on the Zoomer. I have
the data transfer cable from Radio Shack. I can load the Pocket Quicken
Connect on the PC now, but cannot get the Zoomer SW to install on the Zoomer
itself. I'm using Com 1 at 9600 set with "Mode: Com1 baud=96" at the dos
prompt, then start windows etc. The Zoomer is set to "file link, Name:
Alan, Port: Serial Cable, Baud: 9600" and "file transfer: Port: Serial
Cable, Baud: 9600". After I run the install disk, I choose "file manager,
connect, file transfer, switch to transfer mode". I wait for the "waiting
for command from remote PC" message, then click "continue' on PC side. PC
loads a couple of files, then gives message about "unable to connect, check
cable....etc". Got any ideas, I think I've tried all the baud rates on the
Zoomer side. BTW, I've upgraded the Zoomer to the "Expert Mode" geos.ini
and net.ini files.

Any help is appreciated.

Alan
''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''
| Alan Howlett | I BOYCOTT COMPANIES USING |
| Ph: 301.925.0804 | MASS INTERNET ADVERTISING |
| <mailto:ahowlett@eos.hitc.com> |
''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''